BK Precision 9115-AT User Manual download pdf (Page 37)

6. Select Addr… and press . You will be prompted to enter an address. Use current

adjust knob or numeric keypad to enter a number between 0 to 31, and then press

7. For each power supply that you want to control, provide a different address. For

example, if you have three power supplies to control, set the first supply to address 1,

second supply to address 2, and third supply to address 3. If two or more supplies have

the same address, the RS485 protocols will create communication errors.

8. Repeat the above steps for each power supply that you want to connect together and

control, making sure that each of them have a different address assigned.

9. Press several times to exit the menu.

Return Meter

This option allows users to enable an internal fixed timer delay (5 seconds) for the power supply

to automatically switch from setting display to measured display. When enabled, if the power

supply output state is ON (enabled) and if the display shows setting voltage and current, it will

automatically switch to measured voltage and current display after 5 seconds. The backlight of

the button will also be lit. In this state, pushing the again to toggle back to

setting display will reset the 5-second timer again before the supply changes back to measured

display.

To configure this option, follow the steps below:

1. From the SYSTEM menu, browse and select ReturnMeter and press .

2. Select between the two options:

Off(Def) – Return Meter function disabled.

Delay – Enables return meter function.

3. Select the desired option and press to save the change.

4. To exit the menu at any time, press twice.

3.4 CONFIG Menu

All setup procedures and settings explained in this section can be accessed from the CONFIG

menu. To access this menu, press and press . Select CONFIG, then press

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 73 74

No comments

BK Precision 9115-AT User Manual Page 37