BK Precision 9115-AT User Manual download pdf (Page 40)

3. Press when finished making the selection.

4. Press several times to exit the menu.

Select Source Type

For external voltage and current programming of the output, users can configure the power

supply to be controlled with external DC voltages or resistances. Follow the instructions below

to select the source type.

1. From the CONFIG menu, browse and select Ext-Ctrl and press . The following

screen will display:

2. Select the third item V-P or R-P so that it is blinking. Use the keys to change

between V-P or R-P.

V-P – Use external DC voltage source for programming the output.

R-P – Use external resistance for programming the output.

3. Press when finished making the selection.

4. Press several times to exit the menu.

Enable/Disable External Analog Control

If external analog control is not used, it must be disabled before normal front panel operation

can resume. Follow the steps below to enable or disable external analog control.

1. From the CONFIG menu, browse and select Ext-Ctrl and press . The following

screen will display:

Ext – Ctrl Setup

10v-M 10v/10k-P V-P Off

Ext – Ctrl Setup

10v-M 10v/10k-P V-P Off

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 73 74

No comments

BK Precision 9115-AT User Manual Page 40